Oh yes, 3D-printed is sounds like perfect way for this. But this is a "bottom", on this will be mounted slider, but what is on the "top"? Because it must be with LED strip look good. It will be somehow like official slider configurated?
It uses 2mm plexiglass as the overlay. The top part that has 6 screw holes on it clamps the overlay down (it also hides the LED strip). The overlay will be also glued in place on the other end, with 4 screws holding down both the PCB and the overlay on the left and right side
The glued in part is to make sure that my hand won't hit anything like plastic clips or screws when I swipe through while holding buttons. I'm not a huge fan of glued in parts but I made an exception on this since the alternative designs are difficult to execute correctly.
Yeeeahh, I want this! But I'll need little changes for myself, but there will be only some linear dimensions changes, I think
Mar 9, 2020
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Comments on Profile Post by steelpuxnastik